How to Characterize Embedded Serial Buses
Analyzing embedded serial buses with an oscilloscope
Analyzing serial buses in embedded designs requires using an oscilloscope with serial protocol analysis and either deeper memory or segmented memory acquisition. This helps ensure that you can capture analog and digital waveforms over a longer time span and that you can capture more packets. An oscilloscope with segmented memory acquisition enables you to digitize only the important portions of the waveform under test at a high sample rate.
During this test, the segmented acquisition mode on the oscilloscope is turned on. This allows the oscilloscope to ignore unimportant idle time between packets and instead, optimize the number of serial packets captured consecutively or select packets with just a particular ID or address. You can then scroll through the frames to identify any anomalies. Use time-tagging to make latency timing measurements between the frames. Additionally, a time-interleaved lister can display two serial buses and correlate data transfers with other mixed-signal interactions in your system.
Serial bus characterization solution
See demo of serial bus characterization
This is a modal window.
Explore products for our serial bus characterization solution
-
MSOX3054G Mixed Signal Oscilloscope: 500 MHz, 4 Analog Plus 16 Digital Channels
-
N2843A Passive Probe, 10:1, 500 MHz, 1.2 m
-
D3000GENB Embedded Analysis Software for the 3000A/T/G X-Series
-
N2756A MSO Cable Kit, 16-Channel
Discover resources and insights
Additional resources for embedded serial bus characterization
Related use cases
-
How to Debug Electronic Devices with High Accuracy
Achieving quality consumer electronics performance requires debugging small signals, isolating rare glitches, and analyzing serial buses. Learn how to use a high-accuracy oscilloscope to identify and resolve issues within the system quickly.
Learn more
-
How to Analyze Signal Integrity using Layout Geometry
Achieving peak performance in high-speed printed circuit boards (PCB) requires verifying signal integrity (SI) compliance in all electrical traces. Learn how to use layout geometry to generate SI metrics to catch issues earlier and reduce the verification rounds with SI specialists.
Learn more
-
How to Determine DDR5 Controlled Trace Impedance
Addressing signal reflections in DDR5 designs requires properly designed controlled impedance traces. Learn how to use ODB++ files to generate impedance reports and eye diagrams for various data rates and adjust the control impedance to meet specifications.
Learn more
Get in touch with one of our experts
Need help finding the right solution for you?