Lesson 1 - Oscilloscope Triggering Fundamentals

Introduces oscilloscope triggering, including different types of triggers, setup, and how they can be used to capture and view specific signals.

Lesson 2 - What is a Trigger?

Defines what a trigger is and how it works. It discusses the different types of triggers, such as edge, pulse, and pattern triggers.

Lesson 3 - Understanding the Oscilloscope Block Diagram

Provides an overview of the oscilloscope block diagram and how the trigger function fits into the overall system.

Lesson 4 - Trigger Modes

Discusses the different trigger modes available on an oscilloscope, the advantages and disadvantages of each mode, and how to choose the appropriate mode.

Lesson 5 - Trigger Hold-off

Explains how trigger hold-off works and how to use it to prevent the oscilloscope from triggering on multiple instances of the same signal.

Lesson 6 - Trigger Sensitivity

Explains how trigger sensitivity works and how to use it to set the trigger level for a particular signal.

Lesson 7 - Demo Time! Triggering Fundamentals in Action

Provides a demonstration of the different trigger functions discussed in the course and how to set up and use the different triggers.

Lesson 8 - Pulse-width Trigger

Demonstrates the pulse-width trigger function. It explains how pulse-width triggering works and how to use it to capture and view specific pulses.

Lesson 9 - Rise / Fall Time Trigger

Discusses the rise/fall time trigger function. It explains how rise/fall time triggering works and how to use it to capture and view specific signals.

Lesson 10 - Logic Pattern Trigger

Explains the logic pattern trigger function. It explains how logic pattern triggering works and how to use it to capture and view specific logic patterns.

Lesson 11 - Setup and Hold Time Violation Trigger

Discusses how to use the setup and hold time violation trigger to measure the timing of digital signals.

Lesson 12 - Sequence Trigger, Nth Edge Burst Trigger

Teaches how to use the sequence trigger to measure the timing of repetitive events.

Lesson 13 - Pattern Trigger

Discusses how to use the pattern trigger to measure the timing of a specific pattern of digital signals.

Lesson 14 - Serial Protocol Trigger: CAN Bus

Teaches how to use the serial protocol trigger to measure the timing of CAN bus signals.

Lesson 15 - Zone Trigger

Demonstrates how to use the zone trigger to measure the timing of signals that fall within a specific voltage range.

Lesson 16 - Demo Time! Using Zone Trigger to Isolate Infrequent Waveform Anomalies

Demonstrates how to use the zone trigger to isolate infrequent waveform anomalies, which can be helpful for troubleshooting problems.

Lesson 17 - Oscilloscope Triggering Fundamentals

Concludes the course by summarizing key concepts of oscilloscope triggering, along with tips for choosing the right trigger for a particular application.