How to Make 6G D-Band Noise Figure Measurements

Get quote
Signal Analyzer
+ Signal Analyzer
Signal Analyzer
+ Signal Analyzer

Verifying 6G sub-THz designs using noise figure measurements

Early 6G research requires exploring the D-band (110 to 170 GHz) for prototyping and system performance validation. The noise figure of a device under test (DUT) is a crucial RF parameter to measure and characterize the performance of 6G systems. Engineers need a signal analyzer to measure the noise power twice, corresponding to the noise source On and Off while the system downconverter local oscillator (LO) sweeps over the D-band frequency range. The software will automatically control and perform the operation.

The measurement system should have a low noise figure for high accuracy. Test engineers need a signal analyzer to provide self-contained, self-controlled measurements with a noise source and system downconverter. A simple two-step procedure using calibration and measurement can make noise figure measurements. After completing the calibration, test engineers can measure the D-band noise figure on the DUT, which produces noise figure results and enables a quick evaluation of the DUT’s performance.

6G D-band noise figure measurement solution

6G D-band noise figure measurement solution

Measuring and characterizing the performance of the sub-THz 6G systems requires conducting noise figure measurements. The Keysight noise figure measurement solution for D-band frequencies consists of a Keysight X-Series signal analyzer with noise figure measurement application software, a Virginia Diodes (VDI) downconverter and noise source, and a Keysight signal generator as a LO. The noise source provides broadband noise to the DUT input with precalibrated excess noise ratio values. The system downconverter converts the input D-band frequency from the DUT output to a fixed intermediate frequency (IF). The signal analyzer with the noise figure measurement application uses the Y-factor method to calculate the noise figure of the DUT.
Get quote

Explore products in our 6G D-band noise figure measurement

Related use cases

How to Measure the Lowest EVM in WLAN Receiver Test

How to Measure the Lowest EVM in WLAN Receiver Test

Testing the true performance of the device under test (DUT) in WLAN receivers requires a test system that can cancel out the uncorrelated noise contribution from the measurement system to get a much lower EVM for the DUT. Learn how to measure accurate and reliable EVM for the DUT in WLAN applications using the cross-correlated EVM (ccEVM) technique.

Learn more keysight-arrow

How to Measure Wi-Fi 7 Signal Quality

How to Measure Wi-Fi 7 Signal Quality

Measuring signal quality requires capturing a Wi-Fi signal with a signal generator, and analyzing measurements against specified standards. Learn how to use signal analysis software to test Wi-Fi 7 signals to ensure product performance and compliance.

Learn more keysight-arrow

How to Test Power Consumption in IoT Devices

How to Test Power Consumption in IoT Devices

Measuring the low power consumption in IoT devices requires a test system that can overcome signal and power integrity challenges to measure low-power signals in the presence of noise. Learn how to drop the noise floor using a spectrum analyzer test system to allow for measurement of very small signals in IoT devices.

Learn more keysight-arrow

contact us logo

Get in touch with one of our experts

Need help finding the right solution for you?

Contact us